Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
The following chart provides the suggested speed
for various general operations:
Operation
Cutting metal
Deburring metal
Stripping metal
Sharpening metal
Engraving metal
Removing rust
Sanding wood
Polishing
Note: These are suggested speeds.
When using accessories purchased separately, refer to the
accessory instructions for proper speed recommendations. If
in doubt about the proper speed for your operation, test the
performance at low speed settings and gradually increase
until a comfortable speed is found.
Accessories
Warning! Since accessories, other than those offered by
STANLEY FATMAX, have not been tested with this product,
use of such accessories with this product could be hazardous.
To reduce the risk of injury, only STANLEY FATMAX recom-
mended accessories should be used with this product.
WARNING: Do not use a bonded abrasive wheel that is past
its expiration (EXP) date as marked near center of wheel, if
provided. Expired wheels are more likely to burst and cause
serious injury. Store bonded abrasive wheels in dry location
without temperature or humidity extremes. Destroy expired or
damaged wheels so they cannot be used.
Recommended accessories for use with your product are
available at extra cost from your local dealer or authorized
service center.
Warning! Accessories must be rated for at least the speed
recommended on the tool warning label. Wheels and other
accessories running over their rated accessory speed may fly
apart and cause injury.
Use only the accessories shown in the Accessories Chart of
this manual. Accessory ratings must always be above tool
speed as shown on tool nameplate.
WARNING: Handle and store all abrasive wheels carefully to
prevent damage from thermal shock, heat, mechanical dam-
age, etc. Store in a dry protected area free from high humidity,
freezing temperatures or extreme temperature changes.
Accessories Chart
6.35mm Drum Sander
Mandrel
12.7mm Drum Sander
Mandrel
Wrench
12
(Original instructions)
Suggested Speed Settings
20000-30000
20000-30000
12000-15000
Attaching sanding
drums
Changing accessories
32000
30000
30000
15000
30000
15.8mm x 9.5mm
Orange 120-Grit Alu-
minum Oxide Grinding
Wheel Bits
Grinding nails/screws
9.5mm x 12.7mm
Orange 120-Grit Alu-
minum Oxide Grinding
Wheel Bits
1-6.35mm Fiberglass
Cutting bolts, screws,
Cut-off Wheel used with
nails, and thin wood
mandrel
Attaching polishing
6.35mm Screw Mandrel
wheels
6.35mm x 12.7mm
Sanding Drums, 60 Grit,
120 Grit, ard 240 Grit
used with mandrel
Sanding white pine
12.7mm x 12.7mm
Sanding Drums, 60 Grit,
120 Grit, ard 240 Grit
used with mandrel
Polishing and buffing
Felt Polishing Wheels
metals, stone, glass
used with mandrel
and ceramics
Polishing and brighten-
Potsling Compound Vial
ing metals and plastics.
3.175m High Speed
Drilling
Steel Drill Bit
Wire Brush Wheel
Brushing metal
Attaching cut-off discs,
Cut-off Wheel Mandrel,
cut-off wheels, grinding
3.175mm shank
wheels, and emery
wheel
0.79mm Engraving Bit
Engraving metals
Publicidad
