Publicidad
Idiomas disponibles
Idiomas disponibles
Noise and vibration
The declared noise and vibration emission values stated in
the technical data and the declaration of conformity have been
measured in accordance with a standard test method provided
by EN 60745 and may be used for comparing one tool with
another.
The declared noise and vibration emission value may also be
used in a preliminary assessment of exposure.
Warning! The noise and vibration emission value during
actual use of the power tool can differ from the declared value
depending on the ways in which the tool is used. The vibration
level may increase above the level stated.
When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons regularly
using power tools in employment, an estimation of vibration
exposure should consider, the actual conditions of use and the
way the tool is used, including taking account of all parts of
the operating cycle such as the times when the tool is
switched off and when it is running idle in addition to the
trigger time.
Labels on tool
The following symbols are shown on the tool along with the
:
date code:
Warning! To reduce the risk of injury, the user
must read the instruction manual.
Wear safety glasses or goggles
Do not expose the tool to rain or high humidity or
leave outdoors while it is raining.
Additional safety instructions for batteries and
chargers (Not provided with the tool)
Batteries
Never attempt to open for any reason.
u
Do not expose the battery to water.
u
Do not store in locations where the temperature may
u
exceed 40 °C.
Charge only at ambient temperatures between 10 °C and
u
40 °C.
Charge only using the charger provided with the tool.
u
When disposing of batteries, follow the instructions given
u
p
in the section "Protecting the environment".
Do not attempt to charge damaged batteries.
(Original instructions)
Chargers
Use your STANLEY FATMAX charger only to charge the
u
battery in the tool with which it was supplied. Other batter-
ies could burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
Have defective cords replaced immediately.
u
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
$
u
The charger is intended for indoor use only.
+
Read the instruction manual before use.
Electrical safety
#
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on
the rating plate. Never attempt to replace the
charger unit with a regular mains plug.
If the supply cord is damaged, it must be replaced by
u
the manufacturer or an authorised STANLEY FATMAX
Service Centre in order to avoid a hazard.
Features
This appliance includes some or all of the following features.
1. Spindle lock
2. Spindle
3. Collet
4. Collet nut
5. Battery
6. Battery release button
7. On/off button
8. Speed adjustment dial
9. Main handle
10. Accessory storage (for frequently
used bits)
11. Wrench
12. Standard mandrel
13. Screw mandrel
14. Drum sanding mandrel
15. Felt mandrel
Assembly
Warning! Before assembly, remove the battery from the tool.
Charging the battery (Fig. A)
The battery needs to be charged before first use and
whenever it fails to produce sufficient power on jobs that were
easily done before.
ENGLISH
9
Publicidad
