Nederman FilterBox M Manual De Usuario página 28

By default, the FilterBox fan automatically starts
when a tool connected to one of these outlets is used.
But, this feature can be disabled in item 5 'A/M fan
start' in the menu.
• To prevent the fan from stopping during short
pauses in work, a time delay can be set up in menu
"1. Fan off delay".
• Set up autostart of fan [ON/OFF], see
• Set up time delayed fan stop [1–60 min], see
ure 19.
Read Section 2.2 General safety instructions
using the product.
Position the extractor arm hood correctly, see
Figure 1.
See the control panel in Figure
1 Turn the main power switch L to ON.
2 Start FilterBox with the button S1, or switch on
extractor arm hood.
FilterBox is equipped with an overload protector that
automatically disconnects the power if the fan motor
becomes overloaded. For a list of possible causes, see
the Installation and Service Manual.
See Figure 2. If the overload protector is activated, Fil-
terBox goes into OFF mode.
• To reset the overload protector alarm, correct the
problem, and turn the main switch L back to ON.
See Figure 2, item F. LED F is red and indicates that
the fan motor is overloaded.
The overload protector automatically resets after a
few minutes.
• To manually reset the overload protector, turn main
switch L to OFF and then turn it to ON.
Depending on the FilterBox model used, the need to
clean the main filter is indicated by either an audible
alarm or a combination of LEDs, information in the LCD
display and an audible alarm.
If the main filter is not properly clean after re-
peated cleaning, see the Installation and Ser-
vice Manual.
28
Figure 18.
Fig-
before
2.
When the main filter in FilterBox M needs to be
cleaned, it gives off an audible alarm. See
and follow the instructions.
• If compressed air is used to clean FilterBox, it
needs to be connected.
• * Compressed air feed. Use clean air accord-
ing to: DIN ISO 8573-1, class 5/5/4. (7 bar).
• ** Nano: see Section 6.2 Change the main fil-
ter and Figure 20.
See Section 4.6 Automatic filter
Filter cleaning can also be started via the control pan-
el:
1 Press S1 to stop the fan, see
2 Press S2 to start the filter cleaning, see
An audible alarm and the LCD display indicates when
the main filter needs to be cleaned. There are two
ways to start semi-automatic filter cleaning:
1 Press the S2 to disable the alarm, see
alarm can only be inactivated twice before filter
cleaning starts automatically.
2 Or, press S2 twice quickly to start the filter clean-
ing, see Figure 2.
See Section 4.7 Filter cleaning with a preset time in-
terval.
• Wear goggles, dust mask and gloves when
emptying the collector bin.
• Disconnect all power to FilterBox before
emptying the collector bin.
• If a plastic bag is used (NOTE! Meets W3 require-
ments.), see Figure 11.
• If a plastic bag is not used (NOTE! Does not meet W3
requirements.), see Figure
General maintenance is recommended at least once a
year and should always be performed when indicated
with a warning. Filter cleaning and filter changes are
to be performed when indicated with a warning.
Figure 10
cleaning.
Figure 2.
Figure 2.
Figure 2. The
12.