Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
"Setting No Frost Menu" Page
From "Installer menu" page, you can select "No Frost", in order to join to "Setting No Frost".
Pressing the [] key will display:
NO FROST
UN-BALAN.
HEATER Å
HEAT FORC
From "Setting No Frost Menu" page, you can choose desidered "No Frost functions" in order to keep them
Enabled/Not enabled:
- Un-Balan.:
- Heater:
- Heat Forc:
82
when the air external temperature is too cold, if the function is Enabled,
motor-fans automatically start to run, following pre-set ventilation programs.
Appliance will try to use different ventilation procedures that take advantage
of extracted air (warm) to prevent ice formation at the heat exchanger.
ATTENTION: The appliance is default setted with "Un-Balan": not enabled
(factory production).
To Activating/deactivating the function, see: "Activating/deactivating the
function Un-Balan".
(only in case of installing the Pre-Heater optional)
when the air external temperature is too cold, if the function is Enabled, the
Pre-Heater starts to run, for a certain time. Appliance will try to prevent the
formation of ice on the heat exchanger by exploiting the electrical resistance
installed on the extraction channel from the outside.
ATTENTION: The appliance is default setted with "Heater": Enabled
(factory production). To Activating/deactivating the function, see:
"Activating/deactivating the function Heater" .
ATTENTION: In case of "Heater" function NOT Enabled, the Pre-Heater will
not work, also if correctly wired.
ATTENTION: In case of NOT Installed Pre-Heater, keeping "Heater" Enabled,
will produce abnormalities on "No Frost" function.
(only in case of installing the Pre-Heater optional)
when installing the Pre-Heater, a "working test" is possible forcing Pre-Hater
activation. In case of "Heat Forc" Enabled, the Pre-Heater will run for 15
seconds; So after that, the function "Heat Forc" will come back "NOT
Enabled".
[ ▲ ]
UN-BALAN.
HEATER
Pre-set values
NO (not enabled)
YES (enabled)
Publicidad
