Manual rinsing cycle
Water filter
Installing the water filter
WATER
FILTER
1 Place a container under the coffee dispensing spout.
2 Press the AROMA STRENGTH button to select pre-ground coffee. Do not
add pre-ground coffee.
3 Press the ESPRESSO LUNGO button. The machine starts dispensing
water.
4 When the machine stops dispensing, empty the container. Repeat steps
1-3 twice.
5 Press the SPECIAL DRINKS button. Place a container under the hot water
dispensing spout.
6 Press the UP/DOWN buttons to scroll through the options of the display.
Press the OK button to select 'hot water'.
-
The display reminds you have to install the hot water dispensing
spout (if not present), press the OK button to confirm.
7 Press the OK button to start hot water dispensing.
-
Dispense water until the display shows the no water icon.
8 Fill the water tank with fresh water up to the MAX level and remove the
container.
The machine is ready for use.
The Intenza+ water filter is designed to reduce limescale deposits in your
coffee machine and provide filtered water to preserve the aroma and flavor
of each cup of coffee.
1 Remove the small white filter from the water tank and store it in a dry
place.
Note: Please keep the small white filter for future use.You will need it for the
descaling process.
2 Remove the filter from its packaging and immerse it in cold water with
the opening pointing upwards. Press the sides of the filter gently to let out
the air bubbles.
3 Place the filter in the empty water tank. Press it down until it cannot
move any further.
4 Fill the water tank with fresh water up to the MAX indication and place it
the machine.
5 Select the hot water function and dispense hot water until the water tank
is empty (see chapter 'Using the machine', section 'Brewing special drinks').
6 Refill the water tank with fresh water up to the MAX indication and place
it back into the machine.
7 Press the MENU button to enter the menu.
8 Press the DOWN button until the display shows the following icon.
English
13