Makita 2705 Manual De Instrucciones página 8

Sierra de banco
Ocultar thumbs Ver también para 2705:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1
2
► 1. Wrench 2. Offset wrench
CAUTION:
Be sure to hold the hex nut carefully with the
wrench. If your grip should slip, the wrench may
come off the hex nut, and your hand could strike
the sharp blade edges.
Riving Knife/Spreader Positioning
1.
Locate the riving knife/spreader release lever
located at the back of the table saw as shown in
figure 1.
► 1. Riving Knife/Spreader Release Lever
2.
Pull the riving knife/spreader release lever until it
stops as shown in figure 2. This action will release
the riving knife/spreader for positioning.
► 1. Pull the Riving Knife/Spreader release Lever
3.
With the release lever pulled move the riving
knife/spreader up or down by hand to the desired
position. Once the riving knife/spreader begins to
move release the lever and continue to move the
riving knife/spreader to the next setting and it will
automatically lock into position. The riving knife/
spreader is able to lock into 3 positions as shown
in figures 3-5 below.
Three Operating Positions of the
Riving Knife/Spreader Unit
Spreader Position
WARNING:
This position is used for through-cutting
operations and the guard assembly with the
side guards should always be used for this
type of operation. Conducting a through-cut
without proper guarding may result in serous
personal injury.
The riving knife/spreader unit can be made ready for
the attachment of the guard assembly and side guards
by positioning it at the maximum adjustable height as
shown in Fig 3. In this position the unit is raised above
the blade so that the guard assembly can be installed
and made operational. Make sure that the release lever
located at the back of the table saw has returned to
the position as shown in figure 1. Before mounting the
guard be sure to check that the riving knife/spreader
unit is in a locked position by pulling up and pushing
down on the unit to ensure there is no movement.
Spreader Position
1
Fig.1
► 1. Riving Knife/Spreader in Spreader Position
1
Fig.2
8 ENGLISH
1
Fig.3

Publicidad

Tabla de contenido
loading

Tabla de contenido