Riving Knife Position - Makita 2705 Manual De Instrucciones

Riving Knife Position

WARNING:
• Never Operate The Saw With The Guard
Mounted To The Riving Knife/ Spreader
When The Riving Knife/ Spreader Unit Is In
The Riving Knife Position. The guard may
interfere with the feeding of the work piece and
could result in kickback and serious injury.
The riving knife/spreader unit can be positioned and
locked at a height setting that is just below the top of the
saw blade as shown in figure 4. The unit would be used
in this position for non-through cutting operations with the
guard removed such as rabbets and groove cutting. Make
sure that the release lever located at the back of the table
saw has returned to the position as shown in figure 1.
Before operating the tool be sure to check that the riving
knife/spreader unit is in a locked position by pulling up and
pushing down on the unit to ensure there is no movement
Riving Knife Position
1
► 1. Riving Knife/Spreader in Riving Knife Position
Dado Position
The riving knife/spreader unit can be positioned and
locked at a setting that is just below the table behind the
blade as shown in figure 5. This position would only be
used while attempting to perform dado cuts with a dado
type blade. For ease of operation by pulling the riving
knife/spreader release lever the unit will automatically
pop up above the table to provide an easy grasping
area on the unit so that it can be pulled up from below
the table and moved into the next desired position.
Dado Position
► 1. Riving knife/Spreader in Dado Position
Fig.4
1
Fig.5
9 ENGLISH
Riving Knife/Spreader Alignment
WARNING:
• Always make sure the blade is properly aligned with the
riving knife / spreader. If the blade and the riving knife /
spreader are not aligned this could cause interference with
the feeding and/or the pinching of the work piece resulting in
a kickback situation and possible serious personal injury.
• NEVER make any adjustments while the tool
is running. Always disconnect the tool before
making any adjustments, accidental start up of
the tool could result in serious personal injury.
The riving knife / spreader installation is factory-adjusted so that
the blade and the riving knife / spreader are properly aligned.
However, if the blade and the riving knife / spreader come out
of alignment this can be corrected by first unplugging the tool to
prevent unintentional operation. Then the hex bolts as shown in
item 5 should be loosened using the specially provided wrench.
With the hex bolts loosened adjust the riving knife/spreader
so that it is aligned directly behind the blade while maintaining
equal clearance on either side of the riving knife / spreader in
relation to the blade as shown in item 1. Once the riving knife
spreader is located properly lock the mounting means into place
by tightening the hex bolts as shown in item 5.
1
2
► 1. These two clearances should be equal 2. Blade
3. Riving knife/spreader 4. Pressure plate 5. Hex bolts
Blade Guard Assembly Installation
or Removal
1. Release the locking lever pin of the blade guard by
lifting the locking lever tab as shown in figure 1.
3
► 1. Locking Lever in the released position 2. Locking
Lever tab 3. Locking Lever Pin
5
4
3
1
2
Fig.1