Kenwood NEXEDGE NX-230EX Manual De Instrucciones página 21

■ Making Individual Calls (Digital)
If a key has been programmed with [Individual],
[Individual + SDM], or [Individual + Status], you can
make calls to specifi c persons.
1 Press the key programmed as [Individual], [Individual
+ SDM], or [Individual + Status].
2 Press
• You can enter a unit ID directly.
3 Press and hold the PTT switch to make the call.
• Speak into the transceiver as you would during a normal
transmission.
RECEIVING
Select the desired zone and channel. If signaling has been
programmed on the selected channel, you will hear a call only if
the received signal matches your transceiver settings.
Note: Signaling allows your transceiver to code your calls. This will
prevent you from listening to unwanted calls. Refer to "SIGNALING"
on page 25 for details.
■ Receiving Group Calls (Digital)
When you receive a group call on a Conventional channel
and the received group ID matches the ID set up on your
transceiver, you can hear the caller's voice.
When on a Trunking channel, if the Group ID of a received
call matches your Group ID, you will hear the call.
■ Receiving Individual Calls (Digital)
When you receive an individual call, a ringing tone will sound
and the caller's ID will appear on the display. To respond to
the call, press and hold the PTT switch and speak into the
transceiver as you would during a normal transmission.
/ to select a unit ID from the list.
11