Scan Revert; Scan Delete/Add; Priority-Channel Select - Kenwood NEXEDGE NX-230EX Manual De Instrucciones

SCAN REVERT

The Scan Revert channel is the channel selected when you
press the PTT switch to transmit during scan. Your dealer can
program one of the following types of Scan Revert channels:
• Selected: The last channel selected before scan.
• Selected + Talkback: Same as "Selected", plus you can
respond to calls on the channel at which scan is paused.
• Priority 1/ Priority 2: The Priority channel (either Priority 1
or Priority 2) .
• Priority 1 + Talkback/ Priority 2 + Talkback: Same as
"Priority 1/ Priority 2", plus you can respond to calls on the
channel at which scan is paused.
• Last Called + Selected: The last channel on which you
receive a call.

SCAN DELETE/ADD

You can add and remove zones and/or channels/group IDs to
and from your scan list.
1 Select your desired zone and/or channel/group ID.
2 Press the key programmed as [Zone Delete/Add] (to add/
remove zones) or [Scan Delete/Add] (to add/remove
channels/group IDs).
• You can also press and hold the key programmed as [Scan
Delete/Add] to add/remove zones.

PRIORITY-CHANNEL SELECT

If the Priority channel has been set as Operator Selectable by
your dealer, you can reprogram the Priority channels.
1 Select your desired zone and channel/group ID.
2 Press the key programmed as [Priority-channel Select].
3 Press
"PRIORITY 2" (
4 Press
16
/ to select "NORMAL", "PRIORITY 1" (
), or "PRIORITY 1&2" (
to save the setting and exit.
),
).