HP Scanjet 7600 Serie Manual Del Usuario página 18

Chapter 3
Load slides into the TMA light source
1 Insert up to three slides into the slide holder on the bottom side of the transparent
materials adapter (TMA) light source.
Note Make sure that the shiny side of the slide faces the scanner glass when the
TMA light source is in position on the scanner glass. (The emulsion side is dull.)
2 If you are scanning fewer than three slides, insert the slide light shield after you
load the last slide.
Insert a slide into the slide holder with a slide light shield
Load negatives into the TMA light source
1 Load a negative strip into the negative holder. The negative holder is normally
stored in the TMA light source, within the slide holder.
Note Make sure that the shiny side of the negative faces the scanner glass when
the TMA light source is in position on the scanner glass.
Caution
2 If you are scanning a negative strip with fewer than four frames, insert the negative
light shield after you load the negative strip. Use the arrow icons on the negative
light shield to position it correctly.
3 Load the negative strip into the negative holder.
14
Negatives are easily damaged. Touch them only on their edges.
HP Scanjet 7600 series scanner