Mounting Or Removing The Footrests; Operating The Brakes - Vermeiren 708D Manual De Instrucciones

2.4 Mounting or removing the footrests

CAUTION
Check that the footrests are securely locked in place before use.
Keep objects and people away from the footrests swing range.
Mounting the footrests is done as follows:
1. Hold the footrest sideways at the outside of the wheelchairs frame.
2. Mount the holes  of the footrest on the pins  located on the frame.
3. Turn the footrest inwards till it clicks in position. If this lock is a little stiff, press the
lever gently back.
4. Turn the footplate downwards.
5. Replace the calf strap in the hooks .
To take off the footrests:
1. Remove the calf strap by unhooking it on both sides.
2. Pull back the lever  near the footrest attachment.
3. Turn the footrest to the outside of the wheelchair.
4. Lift the holes  of the footrest out of the pins located
on the frame .

2.5 Operating the brakes

CAUTION

The brakes are not used to slow down the wheelchair during movements – Use the
brake only to prevent the wheelchair from unintended movements.

Good operation of the brakes is influenced by wear and contamination of the tires
(water, oil, mud, ...) – Check the condition of the tires before each use.

The brakes are adjustable and can wear – Check the operation of the brakes before
each use.

Make sure the wheelchair is on a flat horizontal surface before releasing the brakes.
Never release both brakes simultaneously.
Risk of injury
Risk of injuries
To apply the brakes:
1. Push the brake levers  forward till you feel a
distinctive click.
To release the brakes:
1. Release one brake by pulling the lever  backwards.
2. Hold the hand-rim of the released wheel with your hand.
3. Release the second brake by pulling the lever
backwards.
7
EN
708D
2019-03
Using your wheelchair
NL