Stihl MS 461 Manual De Instrucciones página 56

English
Since new bar/chain combinations may
be developed after publication of this
Manual, ask your STIHL dealer for the
latest STIHL recommendations.
Cutting attachment MS 461 with loop
handle
Recommended cutting attachments in
compliance with Sec. 5.11 of ANSI
standard B 175.1-2000
Observe the information about ANSI
standard B 175.1-2000 as well as the
definition "low-kickback saw chain" in
the section "Safety Precautions and
Working Techniques".
Rollomatic E guide bars
STIHL reduced kickback guide bars
(with green label)
Bar lengths: 18, 20, 25, 28, 30 in.
(45, 50, 63, 71, 75 cm)
Pitch: 3/8" (9.32 mm)
Groove width: 0.050 in. (1.3 mm) or
0.063 in. (1.6 mm)
Sprocket nose: 10-tooth for cutting
lengths 18, 20 in. (45,
50 cm)
11-tooth for cutting
lengths 25, 28, 30 in.
(63, 71, 75 cm)
54
Rollomatic ES and Rollomatic ES light
guide bars
STIHL reduced kickback guide bars
(with green label)
Bar lengths: 25, 28, 30, 32, 36 in.
(63, 71, 75, 80, 90 cm)
Pitch: 3/8" (9.32 mm)
Groove width: 0.050 in. (1.3 mm) or
0.063 in. (1.6 mm)
Sprocket nose: 11-tooth
Saw chains 3/8" (9.32 mm)
STIHL reduced kickback saw chain
(with green label)
Rapid Super 3 (33 RS3) Type 3624
Pitch: 3/8" (9.32 mm)
Drive link gauge: 0.050 in. (1.3 mm)
STIHL reduced kickback saw chain
(with green label)
Rapid Super 3 (36 RS3) Type 3626
Pitch: 3/8" (9.32 mm)
Drive link gauge: 0.063 in. (1.6 mm)
Chain sprockets
7-tooth for 3/8" (9.32 mm) (rim sprocket)
7-tooth for 3/8" (9.32 mm) (spur chain
sprocket)
In order to comply with the kickback
performance requirements of Sec. 5.11
of ANSI standard B 175.1-2000, do not
use replacement saw chains unless they
have been designated as meeting the
ANSI Sec. 5.11 requirements on this
specific engine unit, or have been
designated as "low kickback" saw
chains in accordance with the ANSI
B 175.1-2000 standard.
Since new bar/chain combinations may
be developed after publication of this
Manual, ask your STIHL dealer for the
latest STIHL recommendations.
EPA / CEPA
The Emission Compliance Period
referred to on the Emissions
Compliance Label indicates the number
of operating hours for which the engine
has been shown to meet Federal
emission requirements.
Category
A = 300 hours
B = 125 hours
C = 50 hours
MS 461