Information Needed By User; Troubleshooting; Maintenance Of The Product; Cleaning The Sprayer - Jacto PJ-16 Manual Del Operador

5. Information Needed by User

5.1. Troubleshooting

• Put about 2 liters of water in the tank.
• While operating the lever, look into the tank to see how the
problem arises.
• Refer to the table and diagram below.
DESCRIPTION
Leakage through the cylinder upper part.
After pumping and
pressurizing the chamber, as you operate the
lever it drops fast.
After pumping and
pressurizing the chamber, the lever rises
quickly when released.

5.2. Maintenance of the product

Every 40 hours, clean the chamber and lubricate all the com-
ponents. Use a pliers to disassemble the parts and a brush with
nylon bristles clean and neutral detergent. Always use personal
protective equipment (PPE).

5.3. Cleaning the sprayer

After finishing the spray application, clean and wash all equip-
ment in an approved decontamination area.
Operate the lever for the internal cleaning of the camera.
Lubricate the parts according to the image below
10/53
CAUSES
Worn or dried out
piston cup.
Cylinder valve
not sealing properly
due to wear or impurities.
Chamber valve
not sealing properly
due to wear or impurities.
Remove the chamber and lubricate the piston.

5.4. Drainage

You must drain it when you finish the use.

5.5. The consequences of improper service

Do not change the sprayer components. Always check for leaks
or malfunction. Follow the maintenance instructions and use
original parts provided by Jacto.
Failure to follow the instructions may cause damage to the oper-
ator's health and the environment.
5.5a. In case of clogged nozzle
Clean nozzles and filters
Do not use metal instruments. Use a brush with nylon bristles
clean and neutral detergent.

5.6. Cylinder maintenance

DISASSEMBLING
• Remove the chamber from the cylinder.
• Remove the nuts (1) from the cylinder.
CORRECTIONS
Replace or lubricate
the pump.
Clean or replace
the valve.
Clean or replace
the valve.
Clean nozzles with brush