En 30 How To Use The Machine; Transporting; Advice On How To Obtain A Good Cut - Dolmar TM-98.14 H2D Manual De Instrucciones

Ocultar thumbs Ver también para TM-98.14 H2D:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

EN 30
with the clutch out! Always engage a low gear before leaving the
machine stopped and unattended.
For hydrostatic drive models:
Go down slopes without touching the pedal (☛ 4.32) to take advantage of the
braking effect of the hydrostatic drive when the transmission is not engaged.

5.6 TRANSPORTING

WARNING!
!
suitable equipment for lifting and an appropriate number of people for
the weight involved and the type of lifting system used. The machine
must never be lifted by rope and tackle. While being transported, close
the fuel stopcock (
ing brake and fasten the machine securely with ropes or chains to the
hauling device.

5.7 ADVICE ON HOW TO OBTAIN A GOOD CUT

1. To keep a lawn green and soft with a good appearance it should be cut regu-
larly without damaging the grass.
2. It is always better to cut the grass when dry.
3. The blades must be in good condition and well sharpened so that the grass is
cut straight without any ragged edge that leads to yellowing at the ends.
4. The engine must run at full speed, both to ensure a sharp cut of the grass
and to get the necessary thrust to push the cuttings towards the exit.
5. The frequency of mowing should be in relation to the rate of growth of the
grass, which should not be left to grow too much between one cut and the next.
6. During hot and dry periods, the grass should be cut a little higher to prevent
the ground from drying out.
If the machine is transported on a truck or trailer, use
if fitted), lower the cutting deck, engage the park-
HOW TO USE THE MACHINE

Publicidad

Tabla de contenido
loading

Tabla de contenido