Time Rescue Recording; Synchro Recording - Yamaha MDX-596 Manual De Instrucciones

TIME RESCUE RECORDING

The Time Rescue (TIME) recording function allows you
to start recording six seconds before you press record.
During record pause mode, the MD recorder monitors
the input signal and continuously maintains a six second
memory "cache". Therefore, you can record a song that
just started without cutting off the beginning. You may
find this function useful when recording live broadcasts,
or when you want to start recording from the beginning
of a song without recording lots of commercials (etc.).
TITLE CHAR. NUMBER
SEARCH M-MARK MONO/ST
SKIP
PLAY PAUSE
1
Press INPUT repeatedly to select the input
connected to the sound source you want to
record.
2
Locate the point where you want to start
recording.
3
Press REC ‡ to set this unit to record pause
mode.
The REC * indicators light up.
"REC Standby" and the amount of time available for
recording flash alternately in the display.
To adjust the recording level of digital or analog input
sources, see "Adjusting Recording Levels" on page 13.
4
Press TIME to start recording when you hear
the beginning of a song you want to record.
Recording starts from the memory cache, allowing you to
record from a point approximately six seconds before you
pressed TIME.
4
DELETE SET
INPUT
1
REC
TIME SYNC
STOP REC
CD-P
3
MDX

SYNCHRO RECORDING

The synchronized recording function lets you set this
unit to start recording automatically when a sound signal
is input. When operating this unit in combination with a
remote controllable Yamaha CD player, you can use the
CD-P button on this unit's remote control to start
playback from the CD player.
TITLE CHAR. NUMBER
SEARCH M-MARK MONO/ST
SKIP
PLAY PAUSE STOP
1
Load the sound source into the source
component.
If necessary, program, or select the track you want
to start recording from before proceeding to the
next step. (Refer to the operation manual supplied
with the source component for instructions
regarding its use.)
2
Press INPUT repeatedly to select the input
connected to the sound source you want to
record.
3
Locate the point where you want to start
recording.
4
Press SYNC to set this unit to record pause
mode.
The REC * indicators light up.
"Synchro REC" and the amount of time available for
recording flash alternately in the display.
During synchronized recording, input sources are recorded
at the current ANALOG and DIGITAL REC LEVEL
setting.
5
Start playing the sound source. (Press CD-P if
recording from a Yamaha CD player.)
The MD starts recording automatically when a sound
signal is input. When the sound signal stops, the unit
switches back to record pause mode and "Synchro REC"
blinks in the display.
6
To continue recording, repeat step 5.
When you have finished recording, press & on
this unit to cancel the record pause mode.
Note
When the signals at the beginning of a track are lower than the
level required to start synchronized recording, they are not
recorded. Should this occur, perform manual recording.
DELETE SET
2
INPUT
REC
4
TIME SYNC
REC
CD-P
5
MDX
E-15