Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Connecting a microphone
By connecting a microphone to the MIC IN jack on the right-side panel, you can use it with the GT-001's
effects.
MEMO
• A condenser microphone, which requires phantom power, can be connected to the MIC IN jack. To supply
phantom power to the condenser microphone, follow the procedures in "3 Editing: Basic Operation" (p. 6),
choosing [MENU] " "SYSTEM" " "INPUT, " and selecting "ON" with the knob [4].
• The GUITAR IN jack for a guitar and the MIC IN jack cannot be used at the same time. If both jacks are
connected, the GUITAR IN jack takes precedence.
* This instrument is equipped with balanced (XLR) type jacks. A wiring
diagram for the jack is shown at right. Make connections after first
checking the wiring diagrams of other equipment you intend to
connect.
* Acoustic feedback could be produced depending on the location of
microphones relative to speakers. This can be remedied by:
• Changing the orientation of the microphone(s).
• Relocating microphone(s) at a greater distance from speakers.
• Lowering volume levels.
Adjusting the contrast (brightness) of the display
You can adjust the brightness of the display.
1.
Choose [MENU] " "SYSTEM" " "LCD."
2.
Adjust the value with the knob [4].
Raising the value (1−16) increases the brightness.
Turning off the Auto Off function
The GT-001 can turn off its power automatically. The power will turn off automatically when 10 hours
have passed since you last played or operated the unit. The display will show a message approximately
15 minutes before the power turns off.
With the factory settings, this function is turned "ON" (power-off in 10 hours). If you want to have the power
remain on all the time, turn it "OFF. "
1.
Choose [MENU] " "SYSTEM" " "AUTO OFF."
2.
Select "OFF" using the knob [1].
3.
Press the [EXIT] button a number of times.
Other Useful Functions
Dynamic microphone
Condenser microphone
2: HOT
3: COLD
1: GND
13
Publicidad
Tabla de contenido
