To Remove The Blade - Husqvarna Soff-Cut 150 E Manual Del Usuario

5. Put 1 blade wrench in the slot at the front of the
motor. Put 1 on blade wrench at the blade shaft bolt
in the blade block.
Note: 2 blade wrenches are supplied with the
product.
6. Tighten the blade shaft bolt (A) clockwise with the
blade wrench.
7. Install the skid plate and the blade block guard.
To install the skid plate and the blade block
Refer to
guard on page 11 .

To remove the blade

1. Pull and hold the release lever when you tilt the
product. Push the handlebar down to set the product
in tilt position.
2. Release the lever to lock the product at tilt position.
10
3. Turn the 2 locking knobs counterclockwise and
remove the blade block cover.
4. Push down on the rear pointer to release the skid
plate.
1038 - 002 - 17.10.2019