To Examine The Drive Belt; To Examine The Skid Plate; To Examine The Wheels - Husqvarna Soff-Cut 150 E Manual Del Usuario

4. Clean the blade block and blade from concrete
particles after each use. Use a heavy duty brush and
water. The remaining concrete (A) will dry and set
(B) if you do not remove it.
A B
5. Keep all openings and slots on the product clean to
make sure that air flows freely through the motor
area.

To examine the skid plate

• Examine the skid plate for damage.
• Examine the slot of the skid plate for too much wear.
• Examine the bottom of the skid plate for too much
burrs.
• Make sure that the skid plate is not twisted.
• Lift the front and the rear of the skid plate. Make sure
that the blade moves freely through the slot of the
skid plate.
• If the skid plate is damaged, replace the skid plate.
To install the skid plate and the blade block
Refer to
guard on page 11 .

To examine the wheels

1. Regularly examine the wheels on your product.
Damaged wheels can decrease the quality of the
result.
2. Do a check that all wheels rotate freely and smooth.
3. Replace the wheels if they show signs of damage or
wear.
1038 - 002 - 17.10.2019

To examine the drive belt

CAUTION: Do not use the product if the
drive belt is damaged. You must replace the
drive belt if it is damaged.
1. Loosen, but do not remove, the 4 screws on the belt
guard.
2. Push from the front and the rear side of the belt
guard.
17