To Install The Skid Plate And The Blade Block Guard - Husqvarna Soff-Cut 150 E Manual Del Usuario

5. Put 1 blade wrench in the slot at the front of the
motor. Put 1 blade wrench on the blade shaft bolt in
the blade block.
Note: 2 blade wrenches are supplied with the
product.
6. Turn the blade shaft bolt (A) counterclockwise until
the wrench in the slot engages on the flat surfaces of
the blade shaft.
C
B
A
7. Remove the blade shaft bolt (A). Remove the outer
blade flange (B). Remove the blade (C) from the
blade shaft (D).
To install the skid plate and the blade
block guard
CAUTION: Always replace the skid plate
when you install a new blade. Do not use a
damaged skid plate.
Note: Make sure that the skid plates are not damaged
during storage.
1038 - 002 - 17.10.2019
1. Put the front of the skid plate on the pin that is
2. Put the rear end of the skid plate on the pin that is
3. Align the 2 knobs of the blade block guard with the
D
4. Lift the skid plate to make sure that the blade moves
installed at the front of the blade block.
installed at the rear of the blade block. Push the skid
plate up until you hear a click.
holes in the blade block. Turn the 2 knobs of the
blade block guard and tighten until it is fully attached
to the blade block.
freely through the skid plate.
11