Switching Your Appliance On And Off; Switching Off And On; How To Adjust The Temperature To Requirements - Bertazzoni REF75PIXL Manual Del Usuario

4. SWITCHING YOUR APPLIANCE ON AND OFF

4.1 Switching On and Off
First Use
When the appliance is connected to the mains
power supply but has not yet been turned on, the
following message will be shown on the display
To switch on all the appliance's compartments,
press and hold the Unit
When first switched on, the FlexMode compartment
is set to Freezer mode.
Shutting off the FlexMode Compartment
This can be shut off only by completely switching
off the appliance.
Press and hold the Unit
Switching On Again
Press on the same buttons to switch on again.
The Freezer compartment remains on at all times
and cannot be shut off except by completely turning
off the appliance.
Press and hold the Unit
Shutting off the Appliance for Long Periods
For long periods of absence, it is advisable to switch
off the appliance by pressing and holding the Unit
button for three seconds and then switching off the
socket or unplugging the appliance.
Empty the appliance of all foodstuffs, clean and dry
the interior and leave the doors and drawers ajar to
prevent the formation of foul odours.
On first use, if text other than Stand-by
appears, this means that the appliance has
already begun the cooling process.
When the appliance first starts up, it
will not be possible to use the Menu to
change the factory settings until the
preset temperature has been reached. It is
nevertheless possible to set the date and
time immediately, as these parameters are
required to activate some special functions.
Each time the appliance is turned on it
performs a self-diagnostic
lasting three minutes before starting up
completely.
If the Refrigerator or Fresh Compartment
only is switched off, the relative fan will
continue to run independently in order to
prevent the formation of mould and foul
odours.
button for three seconds.
button for three seconds.
button for three seconds.
procedure
www.universal.bertazzoni.com
Before shutting the appliance off for an
extended period, remove all foodstuffs
from the interior and leave the doors and
drawers ajar to prevent the formation of
mould and unpleasant odours.
4.2 How to Adjust the Temperature
to Requirements
Each model is carefully tested before leaving
the factory and regulated in order to optimise
performance and energy consumption.
It is normally not necessary to adjust these settings.
The temperature settings can nevertheless be
adjusted as follows, if required:
Refrigerator Compartment
From +2°C to +8°C (35.6°F to 46.4°F): the
recommended temperature is factory set to +5°C
(41°F).
Press the Up/Down buttons to adjust.
The first touch will show the set temperature on the
display. To change it, continue pressing the buttons
until the required temperature is reached.
Freezer Compartment (FlexMode)
From -15°C to -22°C (5°F to -7.6°F): the
recommended temperature is factory set to -18°C
(0°F).
Press the Up/Down buttons to adjust.
The first touch will show the set temperature on the
display. To change it, continue pressing the buttons
until the required temperature is reached.
If the compartment is being used in Refrigerator or
Fresh Mode (FlexMode function), the recommended
and default temperatures will be those which
correspond to the respective compartments.
The displayed temperature may vary
slightly from that set following repeated
opening of the doors, or insertion of items
at room temperature or large quantities of
foodstuffs.
It may take six to twelve hours to reach the
set temperature.
EN
9