Height Adjustment Knob Installation; Installing/Changing Blade; Position The Riving Knife - Delta ShopMaster S36-295 Manual De Instrucciones

HEIGHT ADJUSTMENT KNOB
INSTALLATION
Insert shoulder screw (f) into height adjustment
y
knob (g) as shown in Fig. 11.
Tighten shoulder screw with Phillips Screw driver
y
into Hand Wheel. Height adjustment knob should
rotate freely around shoulder screw when raising or
lowering the blade with the Height Adjustment Hand
Wheel.

INSTALLING/CHANGING BLADE

Ensure riving knife lock lever is in unlocked position
(Fig. 12).
Remove nut and the outer flanged washer from shaft
assembly. Place blade on the arbor shaft with the
teeth on the blade pointing toward the front of the saw.
SHOPMASTER logo on the blade will be facing toward
the left side of the saw. Place flanged washer on the
shaft with the large side of the washer towards the
blade, then secure blade assembly with nut. (Fig. 12)
Tighten nut with blade wrenches (L) from the on-board
storage area on the right side of the saw. Open end
wrench will fit on the arbor shaft between the inner
flange washer and the motor assembly (if necessary,
turn shaft to align flats on the arbor shaft to the wrench).
Closed end wrench will fit on the nut. See Fig. 12a.
Return wrenches (L) to on-board storage location.
Return riving knife lock lever to locked position. Return
throat plate (G) making sure to lock tab on rear of throat
plate under table top as shown in Fig. 12b.

POSITION THE RIVING KNIFE

A riving knife is a flat plate that fits into the cut made by
the saw blade (the "kerf"). It is intended to reduce the
risk of kickback by holding the kerf open and lessening
the tendency of the workpiece to pinch the blade.
To reduce the risk of serious injury,
The riving knife must be installed for every "thru
y
cut" and for every "non-thru
knife would interfere with the cut.
Always use a blade with the correct thickness to
y
match the riving knife. (0.10" (2.6mm) min. kerf
width and 0.073" (1.85mm) max body thickness)
The riving knife must be securely positioned in the
y
"up" or "thru cut" position when using the anti-
kickback pawls and blade guard.
Make sure the riving knife is properly aligned to the
y
blade see Riving Knife Alignment
ASSEMBLY
cut" unless the riving
section.
f
13
g
FIGURE 11
L
WASHER
NUT
G
SHAFT
FIGURE 12
E
UP
THRU
CUT
POSITION
LOCK
LEVER
FIGURE 13
a
b
a
b