Power Connections; Power Source; Extension Cords - Delta ShopMaster S36-295 Manual De Instrucciones

POWER SOURCE

This saw is equipped with a
120-volt, 60-HZ alternating current. See instructions below
regarding proper connections for your saw. For voltage,
the wiring in a shop is as important as the motor's rating.
A line intended only for lights may not be able to properly
carry the current needed for a power tool motor; wire that
is heavy enough for a short distance may be too light for
a greater distance; and a line that can support one power
tool may not be able to support two or three.
DO NOT EXPOSE THE MACHINE TO RAIN OR OPERATE THE MACHINE IN DAMP LOCATIONS.

EXTENSION CORDS

Never use a damaged extension cord.
Check extension cords before each use.
If damaged, replace immediately. Touching the damaged
area could case electrical shock resulting in serious injury.
Keep the extension cord clear of the
work area. Position the cord so it will
not get caught on lumber, tools or other obstructions.
Use the "MINIMUM GAUGE EXTENSION CORD"
y
table, show on the right, to determine the proper
length and gauge for any extension cord used to
supply power to your tool.
Use properly rated extension cords. When using an
y
extension cord, be sure to use one heavy enough
to carry the current required by your machine. An
undersized cord will cause a drop in line voltage,
resulting in loss of power and overheating. The
table shows the minimum gauge to use depending
on the cord length. If in doubt, use the next heavier
gauge. The smaller the gauge number, the heavier
the cord. Only round, jacketed cords listed by
Underwriter's Laboratories (UL) should be used.
When working outdoors, use an extension cord
y
designed for outdoor use.
Save These Instructions.
Refer to them often and use them to instruct others.
If tool is loaned to someone, also loan them these instructions.

POWER CONNECTIONS

15-amp motor for use with a A separate electrical circuit should be used for your
machines. This circuit should not be less than #12 wire
and should be protected with a 20-amp time lag fuse.
Before connecting the machine to the power line, make
sure the switch is in the "OFF" position and be sure that
the electric current is of the same characteristics as
indicated on the machine. A substantial voltage drop will
cause a loss of power and overheat the motor. It may also
damage the machine.
MINIMUM GAUGE EXTENSION CORD
RECOMMENDED SIZES FOR USE WITH
STATIONARY ELECTRIC MACHINES
AMPERE VOLTS
RATING
0-6 120
0-6 120
0-6 120
0-6 120
6-10 120
6-10 120
6-10 120
6-10 120
10-12 120
10-12 120
10-12 120
10-12 120
12-16 120
12-16 120
12-16 120
7
TOTAL GAUGE OF
LENGTH OF EXTENSION
CORD IN CORD
FEET
Up to 25 18 AWG
25-50 16 AWG
50-100 16 AWG
100-150 14 AWG
Up to 25 18 AWG
25-50 16 AWG
50-100 14 AWG
100-150 12 AWG
Up to 25 16 AWG
25-50 16 AWG
50-100 14 AWG
100-150 12 AWG
Up to 25 14 AWG
25-50 12 AWG
GREATER THAN 50 FEET
NOT RECOMMENDED