Operation; Turning The Saw On And Off - Delta ShopMaster S36-295 Manual De Instrucciones

Failure to comply with the following warnings may result in serious personal injury.
READ ENTIRE MANUAL. In addition to reading these operating instructions, it is important to read and understand
the entire manual before operating this saw. Follow all applicable instructions regarding assembly, preparation, and
adjustment prior to making any cuts and comply with all safety rules and warnings in this section and elsewhere
throughout this manual.
EACH TIME YOU USE THE SAW, RUN THROUGH
THE FOLLOWING CHECKLIST:
Are the power source and power connections
y
adequate for the saw?
Are the saw and work area free of clutter and by-
y
standers?
Is the blade tight and properly aligned?
y
Does the riving knife thickness match the blade
y
requirements?
Are the blade and riving knife properly aligned?
y
Is the operator qualified to make the cut and familiar
y
with all of the relevant safety rules, warnings and
instructions included in this manual?
Is the operator and everyone in proximity to the saw
y
wearing appropriate eye, hearing and respiratory
equipment?
Are the bevel angle and height adjustment knobs
y
locked in the proper position?
Is the blade set at the proper height?
y
If ripping, is the rip fence parallel to the blade and
y
securely locked in position?
If crosscutting, is the miter gauge knob tight?
y
If making through cuts with a standard blade, are
y
the blade guard riving knife and anti-kickback pawls
properly attached and properly functioning with
both guards contacting the table surface?
Is there proper clearance and support for the
y
workpiece as it enters and leaves the blade?
Are any cutting aids needed? If so, are they in
y
place, or within reach for proper use?
The use of attachments and accessories not
y
approved by the manufacturer may result in injury.
Replace or sharpen the anti-kickback pawls when
y
the points become dull.
Make sure saw is stable and cut can be
y
accomplished without tipping the saw.
TURNING THE SAW ON AND
OFF
The ON/OFF paddle switch is located on the left side of
the front panel of the saw.
To turn the saw ON lift the switch. Press the switch
down to turn the saw OFF (Fig. 21)
When not in use, the saw should be turned off and the
power switch locked out to prevent unauthorized use.
To lock out power switch, use a standard long shackle
lock, with a shackle that is at least 2-
/
long and no more than
9

OPERATION

/
inch (70mm)
3
4
-inch (7mm) thick.
32
Never use fence and miter gauge together without
y
using a cut off block (gauge) as described in
the Cutting Aids and Accessories section of this
manual.
The proper throat plate must be in place at all times.
y
If your saw makes an unfamiliar noise or if it
y
vibrates excessively, cease operating immediately
until the source has been located and the problem
corrected.
Never perform freehand cutting, plunge cutting, re-
y
sawing or cove cutting.
AVOID KICKBACK
A kickback can occur when the workpiece pinches
the blade, or binds between the saw blade and the
rip fence or other fixed object. This can cause the
workpiece to rise from the table and/or be thrown back
toward the operator. See instructions for reducing the
risk of kickback, in the Table Saw Safety Rules section
of this manual.
IF KICKBACK OCCURS, turn the saw "OFF" and verify
proper alignment of the blade, riving knife and miter
gauge or rip fence, and the proper functioning of the
riving knife, anti-kickback assembly and blade guard
assembly before resuming work.
ON
16
LOCK
OUT
OFF
HOLE
FIGURE 21