Dismantling And Replacement; Replacing The Bulbs - Dolmar TM-92.14 Manual De Instrucciones

MAINTENANCE

6.4 DISMANTLING AND REPLACEMENT

6.4.1 Replacing wheels
Stop the machine on flat ground and put a block
under a load-bearing part of the frame on the side
that the wheel is to be changed.
The wheels are held by a snap ring (1) which can be
eased off with a screwdriver.
NOTE
both rear wheels, make sure they have the same
diameter, and check that cutting deck is horizontal
to prevent an uneven cut.
IMPORTANT
snap ring (1) and supporting washer (2) back in place.
6.4.2 Replacing and repairing the tyres
The tyres are "Tubeless" and so all punctures must be repaired by a tyre repairer fol-
lowing the procedures required for this kind of tyre.

6.4.3 Replacing the bulbs (

The bulbs (18W) have a bayonet fitting and are
installed in the bulb holder which can be taken
out by turning it anti-clockwise with pliers.
If you have to replace one or
Before remounting the wheel, apply grease to the axle. Put the
➤
if present)
33
EN
2 1