Dolmar TM-92.14 Manual De Instrucciones página 93

UNPACKING AND ASSEMBLY
battery and dispose of the battery
in accordance with the regula-
tions in force.
Unfasten the elastic tie rod (2) and
remove the battery and the guard
(3).
Pour the electrolytic solution (4) (acid not supplied: specific
weight 1.280 or 31.5° Baumé) up to the indicated level, dis-
tributing it evenly among the six cells.
Close the six caps (5) supplied and charge the battery.
Put the battery back on the machine. The elastic tie-rod (2)
should be positioned behind the battery filler caps (5).
IMPORTANT
pletely with the help of your dealer, who will have all the right equipment. The battery
charger is NOT able to charge the battery for the first time after activation.
First connect the red wire (6) to the positive
pole (+) and then the black wire (7) to the neg-
ative pole (–), using the screws supplied as
shown.
Apply silicone grease to the terminals and
check that the protective cap for the red wire
(6) is in place.
IMPORTANT
cutting in, never start the engine until the battery is fully charged!
After activating the battery, always charge the battery com-
To prevent the safety device in the electronic circuit board from
3
6
1
2
EN
4
5
7
11