Assigning A Name To A Cd (Disc Memo Function) - Sony MJ-L1 Manual De Instrucciones

Assigning a Name to
a CD (disc memo
function)
You can assign names to your CDs.
Names may consist of uppercase and
lowercase letters, numbers and symbols (up
to 12 characters for each CD). You can store
a maximum of 20 names in the unit.
The name appears in the display when you
insert a CD or press DISPLAY in stop
mode. If you record the CD on a blank MD*
using "CD syncro recording", the name is
stored on the MD automatically.
* A brand-new MD, or an MD which has been
erased using the "all erase function"
POWER m ON
3 5 1
DISPLAY
2 4,9 6
0
DISPLAY
1
Press CD.
The unit enters CD play mode.
2
Press CD § and place a CD.
Be sure the total number of tracks and
total playing time appear in the display.
Note
You can assign names only when the
player is in stop mode and the play
mode is set to normal (SHUFFLE and
PROGRAM are not lit).
3
Press EDIT/NO repeatedly until "Name
in?" appears in the display.
CD
VOLUME
4
Press ENTER/YES.
A cursor flashes in the display.
DISC
CD
cursor
5
Press CHARACTER repeatedly to select
the character type.
Each time you press the button, the
character changes as follows:
nuppercasenlowercase
spaceNsymbols NnumbersN
You can use the following symbols:
! " # $ % & ' ( ) * + , – . / : ; < = > ? @ _ `
(space)
6
Turn the JOG dial until the desired
character appears in the display.
The selected character flashes.
DISC
CD
flashing
To enter a space quickly
7
Press ) when the cursor is flashing.
7
P r e s s ) .
The cursor shifts to the right and stands
by for input of the next character.
DISC CD
Next character
8
Repeat steps 5 and 7 to enter additional
characters until you have entered the
entire name.
If you want to enter the same type of
character, skip step 5.
If you entered the wrong character
Press ) or 0 until the character to
be corrected starts flashing, and repeat
steps 5 to 7 to enter the correct character.
To erase a character
Press ) or 0 until the character to
be erased starts flashing, then press
EDIT/NO.
9
Press ENTER/YES.
This completes the labelling procedure.
To check the name
Press DISPLAY in stop mode.
If you press DISPLAY again, the original
display returns.
1 2 3 4 5
6 7 8 9 10
11
VOLUME
Note
"No name" appears in the display if you
did not assign a name to the current disc.
To delete a name
1 Press EDIT/NO repeatedly until "Name
Erase?" appears in the display.
2 Press ENTER/YES.
Disc names appear in the display.
3 Turn the JOG dial until the disc name
you want to erase appears in the display.
4 Press ENTER/YES.
"Complete" appears in the display for
about two seconds and the selected disc
name is erased.
1 2 3 4 5
6 7 8 9 10
11
VOLUME
1 2 3 4 5
6 7 8 9 10
11
VOLUME
Chapter 2: the CD Player
GB
10