Inserting The Battery - Sony MJ-L1 Manual De Instrucciones

Front
speaker (R) *
STEP 1
STEP 3
* Front speakers are supplied for MJ-L1 only.
STEP 3
Connecting the
Power
Connect the main lead cord to a wall outlet
after you have made all the above
connections.
/
to a wall outlet
Inserting the
Battery
Install a lithium battery in the supplied
remote for remote control.
1
Slide out and remove the battery case.
to a wall outlet
!Do this connection last!
2
Insert a lithium battery CR2025 with the
+ side facing up.
3
Insert the battery case.
CAUTION
Danger of explosion if battery is incorrectly
replaced.
Replace only with the same or equivalent
type recommend by the manufacturer.
Discard used batteries according to the
manufacturer's instructions.
Battery life
You can expect the remote to operate for
about six months (using a Sony CR2025
lithium battery) before the battery run
down. When the battery no longer operates
the remote, replace the battery with a new
one.
FM lead aerial
(supplied)
STEP 2
STEP 1
AM loop aerial
(supplied)
a lithium battery
CR2025
Front speaker
(L) *
STEP 2
To avoid battery leakage
If you are not going to use the remote for a
long time, remove the battery to avoid
damage caused by corrosion from battery
leakage.
Notes on lithium battery
•Keep the lithium battery out of the reach
of children.
Should the battery be swallowed,
immediately consult a doctor.
•Wipe the battery with a dry cloth to
assure a good contact.
•Be sure to observe the correct polarity
when installing the battery.
•Do not hold the battery with metallic
tweezers, otherwise a short-circuit may
occur.
Chapter 1: Setting Up
GB
5