Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
terms
of
the
application.
automatically after reaching the preset number of
impacts.
1.
Pulling the trigger, insert the battery cartridge.
Keep on pulling the trigger after inserting the
battery cartridge. (The indicating lamp on the back
of the tool will flash about 10 times, then the lamp
will keep lighting up lit.)
ON
2
3
001259
2.
Hit the tool housing around the grip once with a
screwdriver etc. (The indicating lamp will go out.)
1
2
001260
3.
Release the trigger. (The indicating lamp will keep
lighting up lit for 0.5 seconds, then the lamp will go
out.)
OFF
001261
4.
Hit the tool housing preset number of first digit
except 0. (The indicating lamp will light up in green
color. Then, the light goes out.)
5.
Pull the trigger, then release it.
6.
Hit the tool housing preset number of second digit
except 0. (The indicating lamp will light up in red
color. Then, the light goes out.)
7.
Pull the trigger, then release the trigger. (The
indicating lamp will light up.)
8.
Remove the battery cartridge. (Presetting has
finished.) (The indicating lamp will go out.)
The
tool
then
1. Indicating lamp
1
2. Switch trigger
3. Battery cartridge
1. Tool housing
2. Screwdriver
stops
CAUTION:
When you change the presetting, do the same
•
procedure as above 1 - 8.
Confirming the presetting
Switch off the tool and insert the battery cartridge. The
indicating lamp will indicate the presetting number.
Green lamp shows the first digit. Red lamp shows the
second digit.
Example: presetting number is 12.
1.
Green color lamp flashes once.
2.
Red color lamp flashes two times.
3.
The lamp goes out.
Relation between presetting number and
action
Presetting
number
0
Auto-stop setting does not work.
01 - 99
After impacting [number of
impacts (presetting number
x 2) x 0.02] seconds.
Green color lamp lights on.
Switch off before impacting
[number of impacts
(presetting number x 2)
x 0.02] seconds.
Red color lamp lights on.
Then, the lamp goes out.
003611
Indicating lamp
After impacting preset numbers, the indicating lamp
•
lights in green color.
The red color light will light on if the trigger is pulled
•
before the presetting number of impacts is
achieved. It indicates that the operation is
incomplete.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing driver bit or socket bit
12 mm
(15/32")
001266
6
Clockwise rotation
Counterclockwise rotation
Auto-stop setting does not work.
Auto-stop setting does not work.
Indication lamp goes out.
9 mm
(3/8")
Publicidad
Tabla de contenido
