Washing Outboard Motor - TOHATSU M 6B Manual Del Propietário

Ocultar thumbs Ver también para M 6B:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

48
INSPECTION AND MAINTENANCE
ENOM00083-0

Washing outboard motor

ENOW00081-0
Do not start engine without removing pro-
peller, or accidentally turning propeller
could cause personal injury.
ENOW00082-0
Never start or operate the engine indoors
or in any space which is not well ventilated.
Exhaust gas contains carbon monoxide, a
colorless and odorless gas which can be
fatal if inhaled for any length of time.
ENOW00920-0
When washing the outboard motor, be
careful not to spray the water inside of the
top cowl, especially electrical components.
ENON00026-0
Note
It is recommended to check chemical prop-
erties of water on which your outboard
motor is regularly used.
10
If outboard motor is used in salt water,
brackish water or water with a high acidic
level, use fresh water to remove salt,
chemicals or mud from exterior and cool-
ing water passage after every cruising or
before storing outboard motor for long
time. Before flushing, remove the propeller
and the forward thrust holder.
ENOM00085-D
Flushing attachment
ENOW00921-0
Do not operate the engine when flushing
the outboard motor with a flushing attach-
WARNING
WARNING
CAUTION
CAUTION
ment as this can cause damage to the out-
board motor.
ENOW00922-0
CAUTION
To prevent the engine from starting when
you are near the propeller, remove the stop
switch lock.
1. Tilt down the outboard motor.
2. Remove the water plug from the gear
case, and screw in the flushing attach-
ment.
3. Connect a water hose. Turn on the
water and adjust the flow (Be sure to
seal the water inlet, located in the gear
case with tape).
4. Put the shift lever in the neutral position
and start the engine. Continue flushing
the outboard motor for 3 to 5 minutes
at idling.
5. Stop the engine and water supply.
Remove the flushing attachment and
tape. After the flushing, be sure to reat-
tach the water plug.
1. Flushing attachment (Option)
2. Water inlet
1
1
2
ENOF01420-0

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

M 8bM 9.8b

Tabla de contenido