ENOM01503-0
2. Periodic Inspection
It is important to inspect and maintain your outboard motor regularly. At each interval on
the chart below, be sure to perform the indicated servicing.
Maintenance intervals should be determined according to the number of hours or number
of months, whichever comes first.
Item
Carburetor *1
Fuel filter
Fuel System
Piping
Fuel tank
Spark plugs
Ignition
Ignition
timing *1
Starter
motor *1
Starting
System
Battery
Starter rope
Propeller
Gear oil
Lower Unit
Water
pump *1
Bolt and Nuts
Sliding and Rotating Parts.
Grease Nipples
Outer Equipment
Anode
*1: Have this handled by your dealer.
ENON00030-0
Note
Your outboard motor should receive careful, and complete inspection at 300 hours. This is the best
time for major maintenance procedures to be carried out.
Servicing Interval
10 hours or
50 hours or
1 month
3 months
INSPECTION AND MAINTENANCE
Every 100
Action
hours or 6
months
Strip, clean and adjust.
Adjust idling.
Check and clean or Replace
if necessary.
Check and Replace if
necessary.
Clean.
Check gaps. Remove
carbon deposits or Replace
if necessary.
Adjust timing.
Check for salt deposits and
battery cable condition.
Check Installation, fluid
quantity, gravity.
Check for wear or damage.
Check for bend blades,
damage, wear.
Change or replenish-oil and
check for water leaks.
Check for wear or damage.
Retighten.
Apply and pump in grease.
Check for corrosion.
Check for corrosion and
deformation.
51
Remarks
0.9-1.0 mm
(0.035-0.039 in)
10
Replace impeller
every 12 months.
Replace.