Positioning Knives For Krone Vp 1500 And Vp 1800 Round Bale Presses - GOWEIL MS 100 Instrucciones De Servicio

Knife sharpener MS 100
Operation

6.11 Positioning knives for Krone VP 1500 and VP 1800 round bale presses

Shown below are special setting specifications for knives used in Krone VP 1500 and VP 1800 round bale
presses!
6.11.1 Setting the adjusting plate/knife position on the adjusting plate
270 mm
The specified dimension is merely intended as a guide value!
6.11.2 Adjusting the grinding unit
6.11.2.1 Retaining plate
The specified dimensions are merely intended as guide values!
275mm
24
. Also make sure that the curved knife is securely clamped into the horizontal clamping device
and rests safely against the end stop bolts.
2. Level the cup grinding wheel and the cutting surface into a horizontal position (0 degrees) (page
21
3. The work flow is the same as described on page 22, item 6.8.1 "Work flow".
NOTICE!
If not needed, the linear grinding unit can be folded away.
TIP!
Setting the right grinding angle is easier for new knives.
IMPORTANT!
The specifications below are guide values as they may vary slightly depending on
the wear on the knives!
adjusting distance, grinding angle
IMPORTANT!
You must turn the rotary unit of the grinding unit by 180° ! See page 20, item 6.5
Correct position of the knife!
40mm
06/2011