Key Commands And Operating Modes - Erreka VIVO-M203 Manual Del Instalador

Connector for AEPS1
(traffic light or brake)
A traffic light can be connected to the AEPS1 card
(supplied separately), by selecting the parameter Ab00.
Colour lights show whether the gate may be crossed or
not.
• Off: gate closed
• Green light: gate open, free to pass.
• Red light: gate moving, forbidden to pass.
• Flashing green light: open gate about to close in
automatic mode.
The same AEPS1 card can, by selecting parameter Ab01,
be used to connect independent brakes (for operators
such as CICLON or MAGIC) instead of the traffic light.
SCA Light
(Cable connectors G9 and G10)
A 24V SCA light can be connected.
• The light remains off when the gate is closed.
• The SCA light remains on without flashing when the
gate is open.
• During opening, the SCA light flashes every second.
• During closing, the SCA light flashes every half a
second.
3

KEY COMMANDS AND OPERATING MODES

Only by radio transmitter (F100)
ST1 total operation, ST2 pedestrian operation (F101)
Photocell shade function
This function allows the photocell to be disabled in the
last part of the closing run. This function is activated
with swing gate (C303), collective opening (A901) and
photocell C5 activated. The invalidation zone is
automatically programmed when programming the
run: when programming closing, the board detects the
position at which the leaf activates photocell C5 and
takes it as the reference point: invalidation will begin
on e m om e n t a ft e r t h e p o i n t d e te c te d d ur i n g
programming, and will finish at the end of the closing
run.
Reset (rS)
Reset is the closed gate (or open gate) position search
at slow speed. The display shows rS. The operator
carries out a reset in the following cases:
• When the electricity supply is restored following
interruption and a key device is activated.
• When the STOP contact is opened and a key device
is activated after closing.
• When the gate collides twice consecutively with an
obstacle and a new key device is activated.
• When the gate stops during opening by pressing the
key device, it then closes and the key device is
activated again.
With F100 selected, the key commands can only be
sent by radio transmitter (pushbuttons ST1 and ST2
remain inactive).
Channel 1 is used for total opening and closing, and
channel 2 is used for pedestrian opening and closing.
M239D
With F101 selected, pushbutton ST1 carries out total
opening and closing, and pushbutton ST2 carries out
pedestrian opening and closing.
DESCRIPTION OF THE PRODUCT
Control board VIVO-M203(M)
65