Erreka VIVO-M203 Manual Del Instalador página 70

DESCRIPTION OF THE PRODUCT
ST1 total opening, ST2 total closing (F102)
Dead man mode (F103)
Dead man mode in closing (F104)
Step-by-step mode (F200)
Opening (with alternative stop): is started by
operating the key device (magnetic key, key switch,
transmitter etc, in accordance with the configuration
F100, F101, F102, F103, F104).
• Collective opening (A901): during opening, the
control board does not obey key commands (the
gate cannot be stopped using key devices).
• Opening with alternative stop (A902): if a key
command is sent during opening, the gate comes to
a stop. A key command must be sent to close it.

If F200 is selected, A903 becomes A902.
66
Installation Guide
With F102 selected, pushbutton ST1 carries out total
opening and pushbutton ST2 carries out total closing.
Opening: this is done by continuously operating the
ST1 key device (magnetic key, key switch, pushbutton,
etc). The radio transmitter cannot be used in this case.
Standby: the gate remains open indefinitely until the
key device is operated.
Closing: this is done by continuously operating the ST2
key device (magnetic key, key switch, pushbutton, etc).
The radio transmitter cannot be used in this case.
Opening: starts by briefly operating key device ST1
(magnetic key, key switch, pushbutton, etc).
Standby: the gate remains open indefinitely until the
key device is operated.
Closing: this is done by continuously operating the ST2
key device (magnetic key, key switch, pushbutton, etc).
The radio transmitter cannot be used in this case.
M239A
Standby: the gate remains open indefinitely until the
key device is operated.
Closing: the closing operation is started by operating
the key device, in accordance with the configuration
F100, F101, F102, F103, F104.

If the key device is operated during closing, the gate
stops, reverses operation direction and then opens
completely.