Cutting Attachment - Stihl HT Manual De Instrucciones

A
2
1
4
Mount the carrying ring (1) at
N
distance A = about 5 cm (2 in) from
the control handle (2).
Push the carrying ring (1) over the
N
drive tube.
Insert the M5 nut (3) in the hex
N
recess in the carrying ring.
Fit the M5x14 screw (4).
N
Line up the carrying ring.
N
Tighten down the screw firmly.
N
HT

Cutting Attachment

A cutting attachment consists of the saw
chain, guide bar and chain sprocket.
The cutting attachment that comes
standard is designed to exactly match
the pole pruner.
1
3
a
The pitch (t) of the saw chain (1),
–
chain sprocket and the nose
sprocket of the Rollomatic guide bar
must match.
The drive link gauge (2) of the saw
–
chain (1) must match the groove
width of the guide bar (3).
If non-matching components are used,
the cutting attachment may be damaged
beyond repair after a short period of
operation.
Chain scabbard
2
Your pole pruner comes standard with a
chain scabbard that matches the cutting
attachment.
3
If you use guide bars of different lenghts
on the pole pruner, the length of the
chain scabbard must be matched to the
guide bar to reduce the risk of injury. It
should cover the full length of the guide
bar.
The length of the matching guide bars is
marked on the side of the chain
scabbard.
English
15