Use/Operators; Intended Use; Improper Use - RK Rose+Krieger DuoLine S Clean Instrucciones De Montaje

4. Use/Operators

4. Use/Operators 4. Use/Operators

4.1 Intended use

The linear unit must be used exclusively for a linear process and positioning of work pieces, units,
measuring devices or for other comparable setting tasks in industrial plants.
Catalogue information, the contents of these assembly instructions and conditions laid down in
the order are to be taken into account.
The load information given in these assembly instructions shows maximum values which must not
be exceeded.
The linear unit is for use in clean rooms. The product certification is done in accordance with ISO
14644. In this regards, the existing clean room classes have been followed. A detailed description
of the test environment and the corresponding results can be found on the test certificate from
the Fraunhofer Institute (see Rose+Krieger homepage).
The linear unit should not be used in areas where there is a risk of explosion or in direct contact
with foodstuffs, pharmaceutical or cosmetic products.
There are versions available with and without vacuum suction available for the different usage
areas and requirements. The proper functioning of the suction equipment requires a suitable
vacuum supply be connected at the prescribed points of the linear axis. The extraction system
must provide a volume flow of 1400 l/min.

4.2 Improper use

"Improper use" shall be assumed when the information quoted in the section 4.1 Intended use is
not observed.
In the event of improper use, incorrect operation and if this linear unit is used, installed or
handled by untrained personnel, this linear unit may pose risks for the personnel.
If the linear unit is used improperly, then RK Rose+Krieger GmbH ceases to be liable and the
general operating licence of this linear unit will be void.
44 44 44