Special Safety Instructions - RK Rose+Krieger DuoLine S Clean Instrucciones De Montaje

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

5.2 Special safety instructions

Work with the linear unit may only take place in accordance with these instructions.
The device may only be opened by authorized specialist personnel. In the event of a defect in
the linear unit, we recommend that you contact the manufacturer or send in this linear unit
for repair.
An electric drive may only be connected to this linear unit by the appropriate technical staff,
in observance of the local connection conditions and regulations (e. g. DIN, VDE).
Electrically operated attachments may only be connected to this linear unit by the relevant
trained specialists, in compliance with the local connection conditions and regulations (e.g.
DIN, VDE).
Motor current monitoring for enhanced safety: monitoring the motor current enables faults
to be detected immediately and to prevent hazards originating from the system.
Wear the necessary personal protective equipment (PPE) at all times during work.
Persons remaining in and reaching into the danger zone of the linear unit when in operation
is forbidden.
Unauthorised modifications or changes to the linear unit are not permitted for safety reasons.
If the linear unit is installed in an oblique or vertical position, the guide carriage must be se-
cured to prevent slipping during work (installation, dismantling, maintenance, servicing).
The transverse forces, torques and speeds specified by RK Rose+Krieger GmbH for this linear
unit must not be exceeded. In dynamic operation, this must be considered for the version: Fx
2
max = m*a [m/s
].
The movement of the linear axis must be limited using technical means in such a way that the
guide carriage is prevented from running into the limit positions.
In the event of damage (e.g. power failure), check the operation of all safety-related elements
(controllers, limit switches etc.).
Following a collision, the toothed belt, track rail guide and carriage have to be replaced – even
if there is no visible damage. Spare parts information is to be taken from the spare parts list
for the relevant linear unit type.
Following a collision, the tapped spindle, guide nut, track rail guide and carriage have to be
replaced – even if there is no visible damage. Spare parts information is to be taken from the
spare parts list for the relevant linear unit type.
The type plate must remain legible. It must be possible to identify the ratings data effortlessly
at any time.
Safety-relevant hazard symbols identify danger areas on the product.
Safety-relevant devices must be inspected at regular intervals, but at least once a year, for pro-
per function, damage and completeness.
5. Safety
5. Safety
5. Safety
47
47
47

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Duoline z cleanDuoline r clean

Tabla de contenido