Operation; Before First Use; Boiling Point Calibration; Inserting Hand Grip - Gaggenau VK 230 714 Manual De Instrucciones

Operation

Before first use

Bear in mind the following instructions before
steaming for the first time:
1 Thoroughly clean the appliance and accessories.
2 When setting it up, a boiling point calibration must
be carried out.
Note: Steaming without first conducting the boiling
point calibration can cause the appliance to
malfunction. It is possible that too much or too little
steam is produced.
3 After the boiling point calibration, fill the cooking
basin with water up to the overflow edge and run
the appliance at steam cooking level for 30 minutes
to eliminate potential smells of newness. Drain the
water and thoroughly dry the cooking basin.

Boiling point calibration

The boiling point is dependent upon air pressure. Since
air pressure drops with increasing elevation, the boiling
point drops as well.
Before steaming with the steamer for the first time, you
have to conduct a boiling point calibration. The steamer
then adapts to the air pressure of the installation site.
Conducting the boiling point calibration
1 Fill cooking basin with cold water up to minimum
mark. Put on glass cover.
2 Turn temperature control knob to 200°F position.
3 Within 5 seconds: Turn the same temperature
control knob back and forth
¥
and 200°F positions. Then turn the temperature
control knob to the
[
The symbol blights during the boiling point
calibration. As soon as the
boiling point calibration is finished. It normally takes
between 3 and 7 minutes.
Note: Extra steam may be produced during the boiling
point calibration.
12
between the
two times
¥
position.
[
symbol stops blinking, the

Inserting hand grip

9
WARNING
Risk of burns
The cooking insert becomes very hot. Only
remove the cooking insert with the provided hand
grip. The hand grip must engage securely on the
cooking insert. The hand grip is not appropriate
for turning over the cooking insert to empty its
contents.
1 Press the hand grip into the slot on the cooking
insert.
2 Fold the hand grip back. Lift up cooking insert with
hand grip.

Turning on

Fill the cooking basin with cold water or another
cooking liquid (fill with 1 - 4 liters, see cooking table).
The cooking basin must not be filled with oil. The
cooking basin must be filled at least to the minimum
mark and at most to the overflow edge.
Turn the temperature control knob to the desired
position. The set temperature is indicated on the
[
display. The symbol lights up on the display as long
as the appliance is heating up.
You can set the temperature from 100 - 200°F. For
steaming, set the appliance for steam cooking level
Note: Make sure that the glass cover is on well during
operation and that the steam outlet isn't covered up.
¥
.