R
5.4 JUNIOR VERSION
Dispensing coffee
•
put the coffee cup under the dispensing spout;
•
press the desired dose key: wait for dispensing to finish (LED comes on);
•
to stop coffee delivery in advance, press the delivery key again or press the STOP key;
•
if the push button panel malfunctions or is locked, use the manual switch.
Programming
•
Place the programming lever in the ON position. It is located under the front right-hand panel of the body;
•
put the coffee cup under the dispensing spout.
•
press the PROG/STOP key for at least 5 seconds until all dose key LED are on.
•
press the desired dose key.
•
to confirm the dose press the dose key or the PROG/STOP key again.
•
repeat this operation for the other dose keys.
•
programming will be terminated automatically after a few seconds.
•
upon completion of programming, place the programming lever back in the OFF position.
WARNING
The programming of every dose must be done with ground coffee and not with previously used grounds.
5.5 EVDT VERSION
Dispensing coffee
•
put the coffee cup under the dispensing spout;
•
press the desired dose key: wait for dispensing to finish (LED comes on);
•
to stop coffee delivery in advance, press the delivery key again or press the
•
to obtain continuous delivery of coffee select the
•
if the push button panel malfunctions or is locked, use the manual switch located near the push button panel.
NOTE
The timer measures the time and not the amount of coffee in the cup. The same programming may provide different amounts
of coffee depending on how the coffee is ground.
Programmazione
1) Press and hold down the
button panel come on. This confirms correct entry into the programming phase.
2) Press on of the two dose keys (2) to program. The LED corresponding to the
(continue) and to the key of the dose being programmed stay on.
3) When the desired amount of coffee in the cup has been reached, press the
key of the dose being programmed to stop delivery and memorize the new value (the
duration of the dose of coffee is calculated in seconds). At the same time, the LED for the
dose which is still to be programmed comes back on, while the LED for the programmed
dose stays off.
4) Proceed with the programming of the other coffee dose by pressing the other dose key.
Once the desired amount of coffee in the cup has been reached, press the dose key or
the
again.
5) To exit programming, press and hold down the
NOTE
It is possible to re-program the coffee dose that you have just fi nished programming (LED off) without necessarily having
to turn the system off and back on or exiting the programming phase.
The system automatically exits programming status approximately 10 seconds after the last operation.
68
english
espresso coffee machine - instructions for the user
. To interrupt delivery press the
for 5 seconds and check that all of the LED on the push
for more than 5 seconds .
;
;
key
2
or the
1