Powerfix KH 3322 Instrucciones De Uso página 96

Adjusting the measurement conclusion
• Press the button
manual measurement conclusion.
The indicator AUTO extinguishes.
• Press the button
conclusions, one after the other. Subject to the fed voltage, the display
of the measurement conclusions begins with one of the following indicator
formats:
-> Measured value in Millivolt (mV) with one decimal place
-> Measured value in Volt (V) with three decimal places
-> Measured value in Volt (V) with two decimal places
-> Measured value in Volt (V) with one decimal place
-> Measured value in Volt (V) without decimal places
After this, the display of measurement conclusions starts again from the
beginning.
• To switch back to automatic measurement conclusions, hold the button
RANGE
e
pressed down for approx. 2 seconds.
Note:
If the indicator OL appears in the display
outside of the measurement conclusion. In this case, enter in a higher measure-
ment conclusion. With open measurement prods and an automatic measure-
ment conclusion, a vacillating measurement conclusion appears in the mV
range, resulting from the high input sensitivity. During the actual measure-
ment a stable and correct indication is given.
RANGE
e
once to switch from the automatic to the
RANGE
e
once again to show the various measurement
- 96 -
z
, the measured value is located