CAMPAGNOLA LN44.1000 Manual De Uso página 30

•
Wear the backpack.
•
Open the back cover to install the twist tie and check that it is positioned in the right direction, but also that it is
not rolled up or knotted. Then carry out the following operations:
1. Open the back cover
2. Press the twist tie reel and rotate it according to the arrow direction
3. Remove the reel cover
4. Insert the reel checking that the the winding direction of the twist tie is the right one
5. Reassemble the reel cover. Press and rotate it according to the arrow direction
6. Hold one end of the twist tie tight
7. By means of the tweezers remove the two twist ties which are out of the reel
8. Insert the twist tie end into its supply track anch check that its direction is the right one and that it is not rolled up
or knotted.
9. After checking the twist tie installation, switch on the battery and pull the trigger. After checking that the twist tie
is driven in the right way, switch off the battery.
10. Check once more the twist tie for proper direction and state, as it is shown in the picture.
11. If the twist tie is perfectly installed, close the back cover.
12. To start working, hold the tool by the handgrip and switch on the battery.
13. At the end of each reel remove any possible residual twist tie from the tool.
14. If the tying operation does not work, remove any residual twist tie by means of the tweezers before working on.
Page 30
Use and Maintenance Manual – Original
Instructions Rev.: 00, Date 29/08/2018