Smart Code Key Installation - BIONIME GM300 Manual Del Usuario

Smart Code Key Installation

How to switch Smart Code Key ?
Every new box of test strips should come with a Smart Code Key inside. Before you install the Smart
Code Key, please check that the code number on the strip vial and the code number on the bottom of
Smart Code Key should be the same.
If you find they are not the same, please return them to the store where you bought from.
1. Turn the meter over. Remove old Smart Code Key by pressing down Smart Code Key release button
if one is installed.
2. With the Meter off, follow ① and ② direction to put the new Smart Code Key into the track on code
key base.
18
3. Push down the Smart Code Key until it snaps into the Smart Code Key base.
PRECAUTION
- Assemble the Smart Code Key into your meter is necessary before starting your test.
- Be sure to change the Smart Code Key with each new box of Rightest
- Use only the Smart Code Key that is packaged with the box of strips you are using.
- Please don't remove this Smart Code Key before you run out of these new strips.
Smart Code Key Installation
® Test Strips.
19