Makita LS1016 Manual De Instrucciones página 11

Socket wrench storage
1
009495
The socket wrench is stored as shown in the figure.
When using the socket wrench, pull it out of the wrench
holder. After using the socket wrench, return it to the
wrench holder.
Installing or removing saw blade
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before installing or removing the blade.
Use only the Makita socket wrench provided to
•
install or remove the blade. Failure to do so may
result in overtightening or insufficient tightening of
the hex bolt. This could cause an injury.
Lock the handle in the raised position by pushing in the
stopper pin.
009483
To remove the blade, use the socket wrench to loosen
the hex bolt holding the center cover by turning it
counterclockwise. Raise the blade guard and center
cover.
1
2
009497
1. Wrench holder
2. Socket wrench
2
1. Stopper pin
1
1. Center cover
2. Socket wrench
3
3. Hex bolt
4. Blade guard
4
Press the shaft lock to lock the spindle and use the
socket wrench to loosen the hex bolt clockwise. Then
remove the hex bolt, outer flange and blade.
009498
NOTE:
When inner flange is removed mistakenly, be sure
•
to install it on the spindle with its protrusion facing
the spindle.
To install the blade, mount it carefully onto the spindle,
making sure that the direction of the arrow on the
surface of the blade matches the direction of the arrow
on the blade case.
Install the outer flange and hex bolt, and then use the
socket wrench to tighten the hex bolt (left-handed)
securely counterclockwise while pressing the shaft lock.
3
009500
2
1
009499
11
1. Shaft lock
2. Blade case
3. Hex bolt
1
2
3
1. Arrow
1
2
2. Arrow
3. Blade case
4. Saw blade
4
1. Hex bolt
3
2. Outer flange
3. Saw blade
4. Inner flange
5. Spindle
5
4