Triton TWX7 CS001 Instrucciones De Montaje página 22

Kerf plate replacement
WARNING: When the Contractor Saw is subject to constant use, the kerf plate may deteriorate. The kerf plate must
remain in good condition at all times. Replace if necessary.
1. Detach the Blade Guard (3) from the Riving Knife (6) by removing the screw that secures the guard to the Riving
Knife
2. Loosen the hex screw located at the infeed end of the Kerf Plate (25), and use the Kerf Plate Access Hole (22) to
release the plate, Fig. F
3. Install the new Kerf Plate and/or Sacrificial Plate
4. Level the Kerf Plate, see 'Kerf plate levelling' for detailed instructions
5. Reinstall the Blade Guard
Cleaning
• Keep the machine clean at all times. Dirt and dust will cause internal parts to wear quickly, and shorten the
machine's service life. Clean the body of your machine with a soft brush or dry cloth. If available, use clean, dry,
compressed air to blow through the ventilation holes
• Never use caustic agents to clean plastic parts. If dry cleaning is not sufficient, a mild detergent on a damp cloth
is recommended
• Water must never come into contact with the tool
• Ensure the tool is thoroughly dry before use
Clearing debris blockages
1. Switch the tool 'off' and disconnect from the power supply. Detach the Blade Guard (3) from the Riving Knife (6) by
removing the screw securing the guard to the Riving Knife
2. Loosen the hex screw located at the infeed end of the Kerf Plate (25), and use the Kerf Plate Access Hole to
release the plate, Fig. F
3. Remove the Dust Chute Panel (12) and any vacuum connections connected to the Dust Extraction Port (9)
4. Locate and clear the debris blockage
5. Reinstall the Blade Guard, Kerf Plate, Dust Chute Panel and any vacuum connections once the blockage has been
cleared
Lubrication
• Lubricate all moving parts with PTFE spray at regular intervals, especially after heavy use or cleaning
WARNING: DO NOT lubricate with oil or silicone-based maintenance sprays. Lubricant residue will combine with wood
and dust, leading to dirt build-up, which may interfere with moving parts and mechanisms. Dry lubricate ONLY, using
PTFE spray.
Storage
• Store this tool and its accessories after use in its case, in a dry, secure place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that are no longer functional and are not viable
for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the correct way to dispose of power tools
7