Cleaning, Maintenance, Storage, Disposal; Cleaning; Maintenance; Upkeep And Maintenance Plan - Zipper Maschinen ZI-RMM95 Manual De Instrucciones

17

CLEANING, MAINTENANCE, STORAGE, DISPOSAL

Cleaning

Wrong cleaning agents can attack the varnish of the machine. Do not use solvents,
nitro thinners, or other cleaning agents that could damage the machine's paint.
Observe the information and instructions of the cleaning agent manufacturer!
Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil.

Maintenance

Danger from electric voltage and compressed air! Manipulation of the machine
with the power supply or compressed air supply upright can lead to serious injuries or
death. Always disconnect the machine from the power supply and compressed air
supply before carrying out any maintenance work.
The machine is low-maintenance and only a few parts have to be serviced. Nevertheless,
malfunctions or defects which could impair the safety of the user must be rectified immediately!
IMPORTANT: deaerate the machine at least every 3 months completely!
Inspection and Maintenance Plan

Upkeep and Maintenance Plan

Clean tyre disc and lubricate clamping jaw
joints.
Lubricate Swing arm (9), mounting bar
(8) and all other moving parts and joints
Check and tighten all screw fittings if
necessary.

Check drive belt tension

Deaerate entire hydraulic system
completely

Check lubricant level

Check the lubricant level in the lubricant container (17). Add SAE 30 oil if necessary.
Check drive belt tension
Remove the cover on the left side of the tyre changing machine to gain access to the drive belts.
For this unscrew the four fixing screws of the cover and remove it.
If the belt is not tightened sufficiently or is dirty or polluted with lubricants, it might slip on the
pulleys and cause stalling. In order to tighten the belt, please adjust it with a bolt being positioned
on the motor plate.

Storage

Improper storage can damage and destroy important components. Only store packed
or unpacked parts under the intended ambient conditions!
In case of a longer interruption of operation or shutdown, clean the machine and then store it out
of the reach of children in a dry place protected from frost and other weather influences !
Disconnect the machine from the power supply and the air compression supply.
Release the tension of the hydraulic system before disconnecting it (16) from the compressed air
supply.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-RMM95
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
N O T I C E
W A R N I N G
Clean tyre disc and lubricate clamping jaw
joints.
Lubricate Swing arm (9), mounting bar
(8) and all other moving parts and joints
Check and tighten all screw fittings if
necessary.
Check drive belt tension
Deaerate entire hydraulic system
completely
H I N W E I S
25