Starting Up The Appliance - Melita Caffeo SOLO & perfect milk Serie Manual De Instrucciones

Before using for the fi rst time
General information
• Only use pure water without
carbonation.
• Use the supplied test strip to determine
the hardness of the water used and set
the water hardness („Water hardness
and fi lter", page 22).
Information for using for the fi rst
time
The appliance must be vented before
it is used for the fi rst time. To do so,
the appliance may only be switched on
without a Melitta
®
with a completely fi lled water reservoir.
• Push the Cappuccinatore 13 onto the
steam pipe up to the stop 12.
• Place a vessel under the
Cappuccinatore 13.
• Press the button to switch on
the appliance.
display.
• Turn the valve switch 11 clockwise until
the stop. illuminates on the display.
Water will fl ow into the vessel.
• When is illuminated on the
display, turn the valve switch 11
counterclockwise until the stop.
• The appliance is ready for operation.
• After using the appliance for the fi rst
time, insert the Melitta
fi lter if required (see page 22).
20
BA_Solo_Perfect_Milk_042015.indd 20 BA_Solo_Perfect_Milk_042015.indd 20
Claris water fi lter and
®
illuminates on the
Claris water
® ®

Starting up the appliance

Starting up
Warning!
Danger of fi re and electric shock
due to incorrect supply voltage,
incorrect or damaged connections
and power cable.
– Ensure that the supply voltage
corresponds to the supply voltage
specifi ed on the identifi cation label of
the appliance. The identifi cation label is
located on the right side of the appliance
behind the cover (Image A, 14).
– Make sure that the power socket meets
the applicable standards for electrical
safety. If in doubt, contact a qualifi ed
electrician.
– Never use damaged power cables
(damaged insulation, bare wires).
• Place the appliance on a stable, dry and
level surface with suffi cient clearance (at
least 10 cm) to the sides.
• Push the Cappuccinatore 13 onto the
steam pipe up to the stop 12.
• Plug the power cable into a suitable
power socket.
• Remove the lid from the bean
container 8.
• Fill the bean container with suitable
coffee beans.
• Put the lid back on.
• Lift up the lid of the water reservoir 7
and pull the water reservoir up and out
of the appliance.
• Fill the water reservoir with fresh tap
water only up to the max. mark.
• Insert the water reservoir into the
appliance.
• Place a vessel under outlet 2.
20.04.2015 21:17:14 20.04.2015 21:17:14