Melita Caffeo SOLO & perfect milk Serie Manual De Instrucciones página 29

Fault
Coffee only fl ows drop-by-
drop.
Coffee does not fl ow.
The grinder is not grinding.
Loud grinder noise
Bean symbols are fl ashing
although the bean container
is full.
The symbol is illuminated
without a reason.
The cleaning or descaling
process was interrupted.
Not enough milk froth is
formed during the frothing
process.
The brewing unit can no
longer be reinserted after
removal.
The symbols for cleaning
and stand-by
alternately.
Continuous fl ashing of all
buttons
BA_Solo_Perfect_Milk_042015.indd 29 BA_Solo_Perfect_Milk_042015.indd 29
Troubleshooting
Cause
Grinding fi neness is too fi ne.
Water tank not fi lled or
incorrectly inserted.
Brewing unit is obstructed.
The beans are not falling into
the grinder.
Foreign objects in the grinder.
Foreign objects in the grinder.
Insuffi cient quantity of ground
beans in the brewing chamber
There is air in the lines inside
the appliance.
The power supply was
interrupted, e.g. due to a power
outage.
The control dial of the
Cappuccinatore is in the wrong
position.
The Cappuccinatore is dirty.
The brewing unit is not properly
locked.
The actuator is not in the
proper position.
The brewing unit is missing or
not properly inserted.
fl ash
The brewing chamber is
overfi lled.
System error
Measure
Adjust the grinding fi neness more
coarse.
Clean the brewing unit.
Perform a descaling or cleaning
programme if necessary.
Fill the water tank and make sure it is
inserted correctly.
Clean the brewing unit.
Tap lightly on the bean container.
Call the hotline.
Call the hotline.
Press the button or
button.
Turn the valve switch 11 clockwise
until the stop until water fl ows out of
the appliance.
Clean the brewing unit if necessary.
The appliance performs a rinsing
program autonomously. To do
so, follow the instructions on the
appliance.
Adjust to the proper position.
Take the Cappuccinatore apart and
clean it.
Check whether the handle for locking
the brewing unit is correctly engaged.
Switch the appliance off and then on
again. Press the and
buttons simultaneously for longer than
2 seconds. The actuator is put into
position. Then reinsert the brewing
unit and make sure it is correctly
locked into place.
Insert the brewing unit properly.
Switch off the appliance and switch
it on again using the ON/OFF button
(repeat if necessary) until standby
mode is displayed.
Switch off the appliance and switch it
on again via the ON/OFF button
; if this does not solve the problem
send the appliance to the service
department.
29
20.04.2015 21:17:15 20.04.2015 21:17:15