Integrated Descaling Programme - Melita Caffeo SOLO & perfect milk Serie Manual De Instrucciones

Cleaning phase 1 (
Two rinsing processes will be executed.
When illuminates, proceed as follows:
• Remove and clean the brewing unit
(„Cleaning the brewing unit", page
24).
• Put a cleaning tab in the brewing unit
(Image C).
• Insert the brewing unit („Cleaning the
brewing unit", page 24).
Cleaning phase 2 (
When illuminates, proceed as follows:
• Fill the water reservoir with tap water up
to the max. mark.
• Press the button to continue with
the cleaning programme (takes about 5
minutes).
Cleaning phase 3 (
When illuminates, proceed as follows:
• Empty the drip tray and coffee grounds
container.
• Insert the drip tray without the coffee
grounds container
• Place the coffee grounds container
under outlet 2.
Cleaning phase 4 (
bean is fl ashing):
• The cleaning programme will be
continued again and takes about 5
minutes.
When illuminates, proceed as follows:
• Empty the drip tray and coffee grounds
container and insert them in the
appliance as usual.
The cleaning programme is fi nished.
BA_Solo_Perfect_Milk_042015.indd 25 BA_Solo_Perfect_Milk_042015.indd 25
):
):
):
, the middle

Integrated descaling programme

Warning!
The descaling agent can cause skin
irritations
Comply with the safety instructions
and the dosing information specifi ed
on the descaling agent packaging.
The integrated descaling programme
(takes about 30 minutes) removes lime
residues inside the appliance. The symbol
for descaling fl ashes during the entire
process.
The descaling programme should be
performed every 3 months, however, at
the latest when illuminates („Setting
the water hardness ", page 23).
Only use Melitta ® ANTI CALC.
• Switch off the appliance.
• Remove the water fi lter if necessary
(„Water hardness and fi lter", page 22).
• Press the and
simultaneously for ca. 3 seconds.
fl ashes, illuminates.
• Empty and reinsert the drip tray.
• Place the coffee grounds container
under the Cappuccinatore.
• Turn the control dial (Image F, 3) to the
"Hot water" position (
illuminates.
• Completely empty the water reservoir.
• Add the descaling agent to the water
reservoir according to the instructions on
the packaging.
• Insert the water reservoir.
• Press the button to start the
descaling programme (takes about 15
minutes).
When illuminates, proceed as follows:
• Ensure that the coffee grounds container
is placed under the Cappuccinatore.
buttons
is pointing up).
25
20.04.2015 21:17:14 20.04.2015 21:17:14