Transport, Storage And Disposal - Melita Caffeo SOLO & perfect milk Serie Manual De Instrucciones

Transport, Storage and
Disposal
Venting
Warning!
There is a risk of burn injuries and
scalding due hot steam and the hot
steam pipe.
– Never touch the steam pipe during
use or immediately after use.
The appliance should be vented when
it has not been used for a while or has
been transported. The appliance is then
protected from frost damage.
• Remove the water fi lter if necessary
(„Water hardness and fi lter", page 22)
and keep it cool in a glass fi lled with tap
water.
• Switch on the appliance.
• Press the
simultaneously for approx. 2 seconds.
fl ashes, and then
• Pull the water reservoir 7 up and out of
the appliance.
• Place a vessel under the
Cappuccinatore 13.
• Turn the valve switch 11 clockwise until
the stop. is fl ashing. Water fl ows out
of the steam pipe and into the vessel;
steam will also escape.
• When there is no more steam
escaping: Turn the valve switch 11
counterclockwise until the stop.
• Insert the water reservoir into the
appliance.
28
BA_Solo_Perfect_Milk_042015.indd 28 BA_Solo_Perfect_Milk_042015.indd 28
and buttons
illuminates.
illuminates.
Transport
• Vent the appliance.
• Empty and clean the drip tray and coffee
grounds container.
• Empty the water reservoir and th bean
container. If necessary, vacuum out
beans that are stuck at the bottom.
• Pull the Cappuccinatore 13 off of the
steam pipe 12.
• „Cleaning the brewing unit", page 24.
• If possible, transport the appliance in
the original packaging including the hard
foam elements.
Disposal
This appliance is labelled according to
the European Directive 2002/96/EC on
waste electrical and electronic equipment
(WEEE). The Directive prescribes the
framework for a EU-wide applicable return
and recycling of waste appliances. Please
contact a specialised dealer for current
disposal procedures.
20.04.2015 21:17:15 20.04.2015 21:17:15