Melita Caffeo SOLO & perfect milk Serie Manual De Instrucciones página 22

Heating milk
• Switch on the appliance.
• Submerse the Cappuccinatore hose 13
directly into the milk.
• Press the button.
the appliance is heating up. After the
heat-up phase,
• Turn the control dial (Image F, 3) to the
"Warm milk" position (
• Turn the valve switch 11 clockwise until
the stop. is fl ashing. The milk is
being heated.
• Turn the valve switch 11
counterclockwise until the stop. The
heating is completed.
• Rinse the Cappuccinatore after each
use.
Rinsing the Cappuccinatore
The Cappuccinatore should be cleaned
at regular intervals („Cleaning the
Cappuccinatore", page 24).
It is recommended to rinse the
Cappuccinatore on a weekly basis with
the milk cleaner system from Melitta
the milk cleaning solution instead of clear
water.
• Switch on the appliance.
• Fill a vessel halfway with clear water.
• Hold a vessel under the Cappuccinatore.
The hose of the Cappuccinatore must be
submersed in the water.
• Turn the control dial (Image F, 3) to the
"Milk froth" position (
• Turn the valve switch 11 clockwise until
the stop. Close the valve switch when a
mixture of clean water and steam comes
out.
• Wait for 30 seconds or press the
button to change to the normal operating
mode.
22
BA_Solo_Perfect_Milk_042015.indd 22 BA_Solo_Perfect_Milk_042015.indd 22
fl ashes while
is illuminated.
is pointing up).
. Use
®
is pointing up).
Dispensing hot water
A maximum of 150 ml of hot water can be
dispensed in each process. To dispense
a larger amount of hot water, repeat the
process.
• Switch on the appliance.
• Turn the control dial (Image F, 3) to the
"Hot water" position (
• Hold a vessel under the Cappuccinatore.
• Turn the valve switch 11 clockwise until
the stop. is fl ashing. Hot water will
fl ow into the vessel.
• Turn the valve switch 11
counterclockwise until the stop.
Water hardness and fi lter
It is important to properly set the water
hardness so that the appliance displays
the need to be descaled in due time. From
the factory, it is set at water hardness 4.
After inserting a Melitta
fi lter, it is automatically set at hardness
level 1.
® ®
Melitta Claris water fi lter
The Melitta Claris water fi lter removes
® ®
lime and other harmful substances from
the water. The water fi lter should be
changed every 2 months, however, at the
latest when appears on the display.
The water fi lter is available in specialised
shops.
Inserting the water fi lter
fl ashes during the entire changing
process.
• Put the water fi lter in a glass with
tap water for several minutes before
inserting it in the appliance.
• Switch off the appliance.
is pointing up).
Claris water
® ®
20.04.2015 21:17:14 20.04.2015 21:17:14