Makita LS1019 Manual De Instrucciones página 10

► 1. Adjusting bolt
► 1. Top surface of turn base 2. Periphery of blade
3. Guide fence
With the tool unplugged, rotate the blade by hand while holding the
handle all the way down to be sure that the blade does not contact
any part of the lower base. Re-adjust slightly, if necessary.
After adjustment, always return the stopper lever to the
original position.
WARNING:
After installing a new blade and with
the tool unplugged, always be sure that the blade does
not contact any part of the lower base when the handle is
lowered completely. If a blade makes contact with the base it
may cause kickback and result in serious personal injury.
1
1
3 2
Stopper arm
The lower limit position of the blade can be easily
adjusted with the stopper arm. To adjust it, turn the
stopper arm in the direction of the arrow as shown in the
figure. Turn the adjusting screw so that the blade stops
at the desired position when lowering the handle fully.
1
► 1. Stopper arm 2. Adjusting screw
Adjusting the miter angle
CAUTION:
After changing the miter angle, always
secure the turn base by tightening the grip firmly.
NOTICE:
When turning the turn base, be sure to
raise the handle fully.
10 ENGLISH
2